Proposed module Specifications • Microphone input with -20dB attenuator • Line input with respectable gain range • Treble shelving at 2 dB increments at 10KHz • Mid peak and trough (dip) 10 frequencies from 700Hz to 16KHz with gain control. • Bass boost with gain control at 5 frequencies 30Hz to 400Hz • Bass cut in 3dB increments, shelving at 80Hz (drawing shows 50Hz) • EQ bypass switch • High pass filter at 80 and 40Hz • Phase reverse on both inputs at the insert return point. • Insert send and return jacks, post input amplifier, pre EQ • XLR connectors for the Mic and Line inputs and final outputs. Jacks for over plugging the mic input and in parallel with the final output. • 9 pin D connector for DC power input • A rack of units will only require a 9 way ribbon connector looped to all modules and plugging directly to the modules. NO CABLEFORMS therefore very cost effective rack housing. ALL connector available world wide. • Transistors will not be the current new types but original Micro Electronics types. Available in: •3u rack mono dual |